The 80 Series remote control works only with door openers and light controls having a green “learn” button and a green indicator light.
Instructions are Described and Illustrated Below
- Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 30 seconds.
- Within 30 seconds, press and hold the selected push button on the hand-held remote.
- Release the button when the motor unit light blinks. It has learned the code. If light bulbs are not installed, two clicks will be heard.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use
The Remote Control Batteries
The lithium batteries should produce
power for up to 5 years. To replace, pry
open case with visor clip or screwdriver,
as shown. Insert batteries positive side
up (+).
Dispose of old batteries properly.
FREE MANUAL PDF DOWNLOAD
LiftMaster: Remote Control – Model 81-315LM Single Button Remote Control
Warning
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
- ALWAYS keep remote controls out of reach of children.
NEVER permit children to operate, or play with remote
controls. - Activate gate or door ONLY when it can be seen clearly,
is properly adjusted, and there are no obstructions to
door travel. - ALWAYS keep gate or garage door in sight until completely
closed. NEVER permit anyone to cross path of moving gate
or door. - NEVER allow small children near batteries.
- If battery is swallowed, immediately notify doctor.
