The 900 Series remote control works only with door openers and light controls having an orange “Learn” button. The additional push buttons can also activate other garage door openers and/or light controls. (Instructions for programming light products are included with those accessories.)

Instructions are Described and Illustrated Below

FREE MANUAL PDF DOWNLOAD

LiftMaster: Remote Control – Model 973W Security+ 3-Button Remote Control

Download Manual Here
  • Erase Codes From Motor Unit Memory
  • Control the Opener Lights
  • Open/Close/Stop Operation
  • The Remote Control Batteries
  1. Press and release the ìlearnî button on the motor unit. The learn indicator light will glow steadily for 30 seconds.
  2. Within 30 seconds, press and hold the button on the hand-held remote.
  3. Release the button when the motor unit light blinks. It has learned the code. If light bulbs are not installed, two clicks will be heard.

To Erase All Codes From Motor Unit Memory

To deactivate any unwanted remote, first erase all codes: Press and hold the ìlearnî button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

To Control the Opener Lights

In addition to operating the door, you may program the remote to operate the lights.

  1. With the door closed, press and hold the remote button that
    you want to control the light.
  2. Press and hold the Light button on the door control.
  3. Press and hold the Lock button on the door control.
  4. After the opener lights flash, release all buttons.

Test by pressing the remote push button. The opener lights should turn on or off but the door should not move.

Open/Close/Stop Operation

NOTE: Not available with universal receiver.
Your remote control can be programmed to operate one door using all 3 buttons: the large button will only open the door, the middle button will close the door, and the third button will stop the door’s movement. You may set up this feature as follows:

  1. With the door closed, press and hold the large remote push button.
  2. Press and hold the Lock button on the door control.
  3. Press and hold the door control push bar.

When the opener lights flash, release all buttons. Test by pressing the large (Open) button on the remote. The door should open. Press it again while the door is open and nothing should happen. Press the middle (Close) button while the door is moving and it should close. Press the third (Stop) button and the door should stop immediately.

The Remote Control Batteries

The lithium batteries should produce power for up to 5 years. To replace, pry open case with visor clip or screwdriver, as shown. Insert batteries positive side up (+).
Dispose of old batteries properly.

Replacement Parts

3V2032 Lithium battery: . . . . . . . . . . . . . . . . . . . . . . . . . .10A20
Visor clip: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137

FREE MANUAL PDF DOWNLOAD

LiftMaster: Remote Control – Model 973W Security+ 3-Button Remote Control

Download Manual Here
  • Erase Codes From Motor Unit Memory
  • Control the Opener Lights
  • Open/Close/Stop Operation
  • The Remote Control Batteries

Warning

To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:

  • ALWAYS keep remote controls out of reach of children. NEVERpermit children to operate, or play with remote control transmitters.
  • Activate gate or door ONLY when it can be seen clearly, is properlyadjusted, and there are no obstructions to door travel.
  • ALWAYS keep gate or garage door in sight until completely closed.NEVER permit anyone to cross path of moving gate or door
  • NEVER allow small children near batteries.
  • If battery is swallowed, immediately notify doctor.

Similar Posts